Agave Assembly

Dragon Tree, Octopus, Sawtooth, Sharkskin, Yucca


 

Dragon Tree, Sawtooth, & Sharkskin

 

PARTS INCLUDED

  • 11 leaf plates
  • base plate

TOOLS NEEDED

  • gloves
  • hammer/mallet

1. Align bolt and post with appropriate openings in leaf plates.

octopus_assembly-00890.jpg
octopus_assembly-00893.jpg

2. Start with leaf #1 (largest) and slide over bolt and post. 

Note: Press and flare out (open wide) first 3 leaves as you place them on the base plate.  This will allow all leaves to stack onto the base.

octopus_assembly-00894.jpg

3. Repeat steps 1 and 2 for remaining 10 leaf plates.

4. Place washer onto bolt and post after all leaves have been secured.

 

 

Octopus

 

PARTS INCLUDED

  • 21 leaves
  • base plate

TOOLS NEEDED

  • gloves
  • hammer/mallet

HELPFUL TIP

  • Hold down base plate with your foot for extra stability while hammering.

1. Pair the #1 leaf with the #1 tab

octopus_assembly-00875.jpg
octopus_assembly-00877.jpg
 
 

2. Gently tap leaf under tab using a rubber mallet. 

octopus_assembly-00886.jpg

3. Repeat steps 1 and 2 for all remaining 21 leaves.

 

 

Yucca • Fluffing the Yucca

 

PARTS INCLUDED

  • 1 flat yucca/joshua head (10 leaf plates)

TOOLS NEEDED

  • gloves

1. Fold the top 5 layers of leaves UP (every other leaf as you go around for best results) to create a “ball” look. 

2. Adjust bottom 5 layers of leaves as desired by folding DOWN to your preference.

3. Mount or stake the base plate down as desired.